How the Cellular System Works

How the Cellular System Works:
Every cellular system digital or analog is comprised of four parts.

1 ) Cells and cell sites ( base stations )

2 ) Switching station ( mobile telephone switching office or MTSO )

3 ) System operator and its local office

4 ) Cellular telephones



The heart of the system is made up of individual radio coverage areas called " cells. " Each cell is a self-contained calling area. Within the cell, a cell site is strategically positioned as a base station for receiving, sending and routing the radio signals of cellular phone calls. Because the cellular system is a radio system, no exact boundary can be drawn on a map. In most cases calls can be place and received throughout the service area, except for certain enclosed areas such as underground parking garages. The No Svc ( No Service ) indicator will illuminate on the cellular phone when in one of those areas or is outside of the service area. The cell site's transmitter is low powered and does not reach much beyond that cell's boundaries. That makes it possible to reuse channels ( frequencies ) - a given channel can be used at the same time in different cells, as long as the cells do not border one another, without causing signal interference. This is particularly valuable in urban areas where lots of cellular phones are in use at the same time. All cell sites are connected to the Mobile Telephone Switching Office ( MTSO ), which provides connection into the Public Switched Telephone network ( PSTN ) - the local telephone company. The MTSO also provides other central functions, including call processing, traffic management, and transferring calls as a phone moves between cell sites.

Making a Call
When a cellular user makes a call from a cellular phone, radio signals are transmitted to the cell site. The cell site alerts the Mobile Telephone Switching Office ( MTSO ) switching station. The MTSO, in turn, provides an open channel ( frequency ) and connects the call to the Public Switched Telephone Network ( PSTN ). The PSTN put the call through to the number to be reached. This process takes the same amount of time that it takes to make a call from a land line phone.

Receiving a Call
These are the steps that occur when you receive a call on a cellular phone. A call placed to a cellular phone may come from either a land line phone or another cellular phone. Whichever the source, the MTSO is notified that a call has been placed to a specific cellular telephone number. At this point, the MTSO searches for the correct cellular phone by sending out data over the radio waves. Cellular phones that are in standby mode ( i.e., turned on but not being used in a call ) continuously scan the radio waves being transmitted by the MSTO. If a phone " hears " its telephone number, it sends back a signal that informs the closest cell site of its Electronic Serial Number ( ESN ) and its telephone number ( Mobile Identification Number or MIN ). The cell site passes this information to the MTSO, where the ESN and MIN are verified and a channel ( frequency ) is assigned for the call. The cellular phone receives the message directing it to tune to the correct voice channel. The cell site makes the voice channel available, and the call is completed.

Hand-off
Hand-off is the transfer of a call from one cell site to another as the cellular phone moves through the service coverage area. The cell site warns the MSTO that the mobile's signal strength is falling below a predetermined level. The MTSO then alerts all cell sites bordering on the first one. They measure the mobile's transmitting signal and report back to the MTSO. The MTSO, which is programmed to select the site receiving the strongest signal, then switches the call from the weak cell to the strongest cell without interrupting the call. The whole process takes a fraction of a second, and the caller usually is unaware of it. Such hand-offs may occur several times during a single conversation as the caller moves through the coverage area.

(Copy from gsmreport.dot5hosting.com)